Facebook
LED Moving Head Light

Five-Head Beam Wash, Spec by Spec

Tornado 5H sits at the centre of the Lite Vision range, and its product page publishes the figures buyers actually shortlist on. If you are sourcing a led moving head light for a venue build, a rental fleet or a distribution line, the same sheet answers the questions that come up around a moving head dj light for club and booth installs: 5 × 120W main LEDs plus a 120 × 0.5W RGB outer ring, 13,000 lumens of total fixture output, a 3°–30° zoom and 41/71CH control. Every brief below is matched to the number that decides it.

  • 5 × 120WMain LED sources
  • 13,000 lmTotal fixture output
  • 3°–30°Beam angle, zoom
Tornado 5H 5x120w RGBW 5heads moving head beam wash stage lighting

Match the brief to the specification

Five common buying briefs, each tied to the exact figure on the product page that settles it — and to the decision you should make before you request a quote.

Club & DJ booth

Small floor, tight ceiling

Spec that decides itPan 59° and tilt 221° with 16-bit resolution and automatic position correction, plus a 3°–30° zoom that moves from a tight beam to floor wash without changing fixtures.

Buyer decisionCheck the 1002 × 196 × 334 mm footprint against your fixing points, and plan one 935W circuit per fixture.

Mid-size touring

Rental fleets and repatching

Spec that decides itDMX512 and RDM with two protocol modes at 41/71 channels, and firmware upgrades sent straight down the DMX link.

Buyer decisionChoose the channel mode you will run, then reserve that patch space per fixture when you cost the universes.

Outdoor & festival

Covered stage and connector choice

Spec that decides itProtection rating IP33, with waterproof True1-type power in/out and 3-pin XLR data in/out for clean chaining.

Buyer decisionIP33 is a dry, indoor rating — specify the unit under a roof or covered stage and let the True1 connectors handle the loom.

Studio & broadcast

Repeatable looks, low light levels

Spec that decides it0–100% dimming, colour mixing and colour macro effects, variable-speed strobe and a linear focusing structure.

Buyer decisionAsk for a dimming check at the low end on a single unit before committing a full studio order.

Audience & blind coverage

More beams from fewer points

Spec that decides itFive heads carried on one fixture at 13,000 lumens total, with pan 59° and tilt 221° to spread coverage across a front-of-house position.

Buyer decisionFewer hanging points, but 26.6 kg per unit — recalculate point loads and truck-pack case sizing.

Distribution

One SKU for several looks

Spec that decides itA zoom range of 3°–30° beam and 4°–35° field, plus colour macros and a 20,000-hour LED life expectancy.

Buyer decisionStock depth becomes easier to justify when a single model covers both beam and wash briefs in your catalogue.

Tornado 5H: the full parameter set

Everything below is taken from the model's own product page, grouped the way a spec sheet is read during a tender or a stock review.

Tornado 5H 5x120w RGBW 5heads moving head beam wash stage lighting

Read the table against your rig plan: one 935W draw and 26.6 kg per unit are the two numbers that shape distro and truss decisions.

Light source
Main light5 × 120W LEDs
Outer circle120 × 0.5W RGB LEDs
Total lumen output13,000 lumens (fixture)
Life expectancy20,000 hours
Optical system
Beam angle3°–30°
Field angle4°–35°
FocusingLinear focusing structure
Control and program
ProtocolsDMX512, RDM
DMX protocol modes2
Control channels41/71CH
Control panel4-button touch panel with LCD display
Firmware upgradeVia DMX link
Pan and tilt
Pan movement59°
Tilt movement221°
Resolution16 bit
CorrectionAutomatic pan/tilt position correction
Effects
StrobeVariable speed
Dimming0–100%
ColourColour mixing and colour macro effects
Electrical and connectors
Input voltage100–240V~ 50/60Hz
Power consumption935W
Power in/outWaterproof True1-type connector in/out
Data in/out3-pin XLR
Fixture specification
Dimensions1002 × 196 × 334 mm
Net weight26.6 kg
Protection ratingIP33
Tornado 5H 5x120w RGBW 5heads moving head beam wash stage lighting

Five heads, one hang point

What the multi-head layout actually changes for a buyer is how much coverage one position delivers — and how much rigging time that saves.

  • Output per position13,000 lumens from 5 × 120W main LEDs, with a 120 × 0.5W RGB outer ring for accent colour.
  • One unit, two looksA 3°–30° beam angle and 4°–35° field angle let the same fixture deliver a tight beam or a wide wash.
  • Repeatable aiming16-bit pan/tilt resolution with automatic position correction keeps set positions repeatable between shows.
  • Effects on boardVariable-speed strobe, 0–100% dimming, colour mixing and colour macros, all driven from the LCD and 4-button panel.
  • Service without opening casesFirmware moves over the DMX link, so a fleet update does not require bench time per unit.

How to read these numbers

Four figures do most of the work when you compare moving heads. Here is what each one means on a real purchase decision.

1

Lumens versus usable light

The page quotes 13,000 lumens as the total output of the fixture, so read it as the output of the whole unit rather than of a single beam. When the zoom narrows toward 3°, the same output is concentrated into a smaller pool — that concentration, not the headline figure, is what you see on stage.

2

Beam, wash and spot angles

Beam angle (3°–30°) describes the tight core; field angle (4°–35°) describes the softer edge around it. The field angle is always the wider of the two, so plan aerial beam looks at the narrow end and floor or wall coverage at the wide end.

3

Channel count and control

Two DMX protocol modes at 41/71 channels let you trade patch space against control resolution. On a big rig, the lower count keeps more fixtures on a universe; on a feature position, the higher count is worth the space.

4

IP rating and rigging weight

IP33 is a dry-environment rating, so this fixture belongs under a roof or on a covered stage. At 26.6 kg and 935W each, point loads, truss capacity and power distribution should be calculated per fixture before the order is confirmed.

Two buying briefs, one fixture

The same specification serves a trade buyer building stock and an installer fitting out a small venue. What changes is which line of the sheet you lead with.

For rental fleets and distributors

A trade catalogue needs a model that answers several briefs without a separate SKU for each.

  • One zoom range (3°–30° beam, 4°–35° field) covers both beam and wash enquiries.
  • RDM addressing and DMX-link firmware updates keep a mixed fleet manageable on site.
  • True1-type power in/out and 3-pin XLR data in/out chain quickly during changeovers.
  • 20,000-hour LED life expectancy simplifies the service and spares conversation.

Ask for: quantity, destination voltage, and the DMX mode you intend to standardise on.

For DJ booths and small venue installs

In a low-ceiling room, coverage per hanging point matters more than raw fixture count.

  • Five heads on a single 26.6 kg fixture spread beams across a front-of-house position.
  • Pan 59° and tilt 221° with 16-bit resolution hold the same looks night after night.
  • 0–100% dimming and colour macros give operators usable looks without deep programming.
  • IP33 keeps the install indoors — fixed under a ceiling or a covered structure.

Ask for: ceiling height, fixing-point details, and a single-unit demo before a full install order.

Send the brief, get a configured quotation

Tornado 5H is quoted rather than sold from a cart, so the fastest route to pricing and lead time is a short brief with the details an engineer needs.

  • Venue type — club, touring, studio, covered stage or fixed install
  • Quantity of fixtures and whether spares are required
  • Supply voltage within the 100–240V~ 50/60Hz range
  • Control protocol — DMX512 or RDM, and the channel mode you plan to run
  • Rigging constraints — point loads, truss type and case logistics
Request a quote

Use the contact page to send your venue type, quantity, voltage and control protocol. Bulk orders, OEM/ODM and customisation requirements can be raised in the same message so the reply covers specification and terms together.

Contact Us

Direct: jason@lite-vision.com · +86 15999720935

Related Reading

Three notes to help clarify product requirements before contacting the supplier.

Multi-Head Beam Wash Lights in Modern Concert Stage Design

A multi-head beam wash fixture puts several aimable heads inside one housing, and that single design choice explains why the format keeps appearing in modern concert stage design.

Read article

How Does a Five-Head Moving Light Change Stage Coverage?

A five-head fixture puts five aimable light sources inside one body, which shifts how coverage density, hanging positions, and cable runs are planned for a large stage.

Read article

Beam and Wash Output in a Multi-Head Moving Light Fixture

Beam and wash name two different viewing jobs, and one multi-head fixture can deliver both without publishing a measured beam angle.

Read article

Frequently Asked Questions

what is the tornado 5h?

it is a five-head moving head beam wash fixture built around 5 × 120w main leds plus an outer circle of 120 × 0.5w rgb leds, with 13,000 lumens of total fixture output and a 3°–30° beam angle.

can it be used outdoors?

the protection rating is ip33, which is a dry-environment rating. plan it for indoor use or under a roof or covered stage, using the waterproof true1-type power in/out and 3-pin xlr data in/out for clean connections.

how many dmx channels does it need?

the fixture offers dmx512 and rdm with two dmx protocol modes at 41/71 channels. decide which mode your rig will standardise on, then reserve that amount of patch space per fixture.

what are the power and weight figures per fixture?

each unit draws 935w from a 100–240v~ 50/60hz supply, measures 1002 × 196 × 334 mm and weighs 26.6 kg net. both the power draw and the weight should be checked against your distribution and truss plan.

what control and effects are included?

an lcd display with a 4-button touch panel, 16-bit pan/tilt with automatic position correction, variable-speed strobe, 0–100% dimming, colour mixing and colour macro effects, and a linear focusing structure. firmware upgrades run over the dmx link.

how do i get pricing, lead time and bulk terms?

there is no price or checkout on the product page; the route is a quote request through the contact page. send venue type, quantity, supply voltage and control protocol, and add any oem/odm, customisation or bulk-order requirements to the same enquiry.